NotSharpEnuff

There are a few options. One is to go for a wider angle. I know that’s a compromise, but it will work and you don’t need anything extra.

If you want alternatives to the low angle adapter then check out this thread: Down & Dirty LAA Mod

I would like to say that these are a great accessory. They work exactly as advertised with no risk of marring the guide rods. The stops beneath the stones prevent you from accidentally scratching the face of your knife and the stops above your stone prevent you from accidentally slipping off of the edge. This is a great safety improvement because…[Read more]

Go check out MarcH’s thread on How I find the sweet spot. The answer you seek is in that thread. Basically, you just need to play around with the position of the knife in the clamp a bit more in order to find a spot that is a better compromise. My guess is that you need to clamp closer to the tip and get the blade higher in the jaws if possible.…[Read more]

I remember from a video that Josh made that the number of washers went back and forth during the prototyping stage of the clamp development. I don’t think there’s any problem caused by removing a set of the washers.

This is why it is best to use results rather than an arbitrary number of strokes to guide the sharpening process. You probably failed to apex the bevels. You will be well served to go back to a lower grit and sharpen until you feel a burr.

Nice work!

I’m enjoying seeing the process of the conversion, but that looks like tons of work.

For the amount of effort it takes to modify a Harbor Freight belt sander into a suitable sharpening platform I’d gladly just pay more for one of the name brand setups that’s ready to go out of the box. I’m lazy.

Welcome Lasse!

Yes, the Wicked Edge sharpeners are expensive but also amazing and totally unmatched in precision and quality. With all of your sharpening experience I’m sure you can truly appreciate the ease of use and consistency of the results that these fine tools provide.

This is the one that WE sells:

Wixey WR300 Type 2 Digital Angle Gauge

I have this one:

https://www.amazon.com/AccuRemote-Digital-Electronic-Magnetic-Protractor/dp/B006JR8XBG/ref=sr_1_1?crid=3FKH7ATSZSKS9&keywords=accuremote&qid=1562974938&s=industrial&sprefix=acuremore%2Ctools%2C166&sr=1-1

Welcome Rosalie!

I hope you will like it here.

Greetings from Denmark!

Jens

Welcome Rosalie!

Do you currently own a Wicked Edge sharpener? If so, which model?

I think all of those knives will fit. The very narrow knives (fillet and paring) might require the use of an obtuse angle to prevent the clamp from getting in the way of the sharpening stones. The low angle adapter can help with that. Also, fillet knives require extra care since they are usually quite flexible, but they can be sharpened.

Wow, 11/11! You are indeed a steel nerd.

Your knives will still get sharp during the break in period for the stones. Once the stones are worn in then the knives will become sharp to a greater degree.

You dont one have to spend multiple hours on a knife especially if you don’t care about how shiny the edge is. The first time you sharpen each knife will take some time (how long depends o…[Read more]

There’s also this one:

http://amktactical.com/AMK-75-1×30-Knife-Sharpener

Thanks for the detailed response Clay!

Nice work!

That had a very coarse finish on it in the before photos. Was that a factory edge?

Marc’s advise is good, but I’ll offer an alternative option.

If you’re dead set on having a highly polished finish this time around I suggest going back a few grits perhaps to the 800 or so and then working your way back to where you are now. Work with extra care and attention to detail. This will get you the results you’re after and you don’t…[Read more]