James Wilson

[James Wilson]

I found the article I was looking for from graphite. The cam follower was a little tight. I sanded it lightly and now all is smooth.

Thank to all for the help.

3 users thanked author for this post.

wickededge, Organic, Marc H

[James Wilson]

I switched the jaws and it now measures within about 1/4 degree. Thanks to everyone for the advice.

2 users thanked author for this post.

Organic, Marc H

[James Wilson]

tcmeyer thank you for your reply. I will try switching the jaws. I have tried a flat piece of metal and it also leans. I know about the angle cube it has been zeroed on the base.

march thank you for your reply. the vice is an upgrade from an earler version so it is like the we130. measuring by holding the zeroed angle cube on the knife. their is 1 degree difference between right and left. I have also tried tcmeyer method with the same results. I will repost when I have switched the jaws.

2 users thanked author for this post.

wickededge, Marc H

[James Wilson]

I would try some lube on the threads. Also lube the end of the lower screw, where it touches the clamp.

[James Wilson]

It is a FARE not a FAIR.

[Author]

Posts