Bob

Welcome to the forum

Welcome Wayne, you’re gonna love your pro pack

Welcome Ben

Thanks tcmeyer, it looks like it works great.  Since I have a wooden workbench I would look for a screw down base instead of a suction cup mount, which hopefully will work just as well.

tcmeyer,  is tne RAM mount something that you put together or bought complete?  Either way could you post a link as to where to get it?  Looks like it will really do the trick.

I thought I posted this before but I can’t seem to find it anywhere. If I did I’m sorry for my redundancy

Thanks Marc for the marker tip.

I purchased the standoffs at Suburban Bolt & Supply in Roseville Michigan.  I originally bought them for some magnetic locks that I was installing and had them left over from that job, the original hole was 3/16 I drilled it out to 17/64,  then I drilled and tapped them with a 10/32 tap.  The screws were also pur…[Read more]

Marc, Worked like a charm,  fortunately it held tight because there really isn’t any room to put leather in it, maybe a piece of a rubber glove if it starts to slip.

Bob

Thanks for your reply Marc,

I guess I use the wrong word, flex is what I mean.  The vice hold the blade quite securely, but because of the thinness  of the blade it has a lot of flex.  What is was thinking about doing,  is cutting some 1/16  angle stock 2 x 1/4 and clamping the knife between those two pieces.  When I get it done I will post a pic…[Read more]