ColbyL

[ColbyL]

Wow Robert those are some nice add ons!  I will keep those in mind as I go down the rabbit hole…  For now I am planning on cutting the fingers off some disposable gloves and put them over the ball joints.  I am curious about your stones.  Are those covers on them?  I am trying to figure out the best way to store mine and was considering putting each on in a ziplock bag and then getting a little box to hold them all.

[ColbyL]

My arms are .253 according to my calipers so I think I am within spec there.  I called Wicked Edge and they are sending me new joints (impressive customer service as I had heard).

I am interested in seeing the new joints.  The ones I have now seem a little worse for the wear.  There are some gouges in the face of one of them almost like they had been used and not treated nicely.  The supplied alignment guide also looked like it had seen better days with most of the markings partially worn off.

Marc – Thank you for the tip on threaded the rods into the joints.  Mine were already installed and I hadn’t touched them but I will keep this in mind when the new ones come.  I have used teflon tape in place of locktite in the past for things like this with decent success.

1 user thanked author for this post.

Marc H

[ColbyL]

OK thank you Robert and Marc, I thought that seemed like a lot of movement in those joints.  They are both equally bad.  I will call support and discuss with them.

Regarding the stones on the arms.  Here is a video, with audio, of the movement I am getting on those.  Its roughly the same on both arms with all the stones.

View post on imgur.com

[ColbyL]

Thank you for the reply Marc.  I did purchase directly from Wicked Edge.  I bought the WE130 and some extra stones.  I think this picture should get you everything requested.  Let me know if you need another angle.

Edit: Here is a link of a video showing the play at the joint.  https://imgur.com/a/tHTmG02

• This reply was modified 3 years, 12 months ago by ColbyL.

Attachments:

You must be logged in to access attached files.

1 user thanked author for this post.

000Robert

[Author]

Posts