Advanced Search

Rod Bumper and cover

Recent › Forums › Main Forum › Sharpener and Accessory Maintenance › MODS › Rod Bumper and cover

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 09/13/2019 at 11:48 am #52040
    Joe
    Participant
    • Topics: 1
    • Replies: 0

    Made a rod bumper out of extra headphone ear piece. A lot of headphones now a days come with extra rubber pieces so you can size the earphone in your ear. That fits nicely on the rod.

    Cover is made out of the corner of a plastic sandwich bag.

    • This topic was modified 4 years, 7 months ago by Joe.
    • This topic was modified 4 years, 7 months ago by Joe.
    Attachments:
    3 users thanked author for this post.
    Richard, Mike, Marc H
    09/13/2019 at 1:24 pm #52049
    airscapes
    Participant
    • Topics: 19
    • Replies: 367

    That’s a great idea!  Be careful pulling them off, the rod can get away from you when they  come off the end and smack your nice new bevel. Happened a couple time with the TPU stops I made.  You are pulling with one hand an not holding the rod tight enough with the other.

    Hummm that didn’t sound got good.. did it 🙂

    • This reply was modified 4 years, 7 months ago by airscapes.
    2 users thanked author for this post.
    Joe, Brewbear
  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.