Advanced Search

Plane & Chisel attachment

Viewing 11 posts - 1 through 11 (of 11 total)
  • Author
    Posts
  • #17446
    Bill Sutherland
    Participant
    • Topics: 9
    • Replies: 31

    I see there is a new Plane and Chisel attachment and wondered if anyone has used this yet and what your impression/results have been?

    #17458
    Jake Braitman
    Participant
    • Topics: 0
    • Replies: 5

    I am curious as well. I’ve been eyeing it for a couple weeks. If anyone has a review I would love to hear it.
    Thanks
    Jake

    #17459
    wickededge
    Keymaster
    • Topics: 123
    • Replies: 2939

    Bill and Jake,

    Do you guys have a lot of chisels and planes to sharpen?

    -Clay

    #17460
    Jake Braitman
    Participant
    • Topics: 0
    • Replies: 5

    I have a bunch to sharpen. About 20 chisels and hand planes each.

    #17462
    Bill Sutherland
    Participant
    • Topics: 9
    • Replies: 31

    LOL, yes I have a bunch to sharpen even though I’m so busy I haven’t been in my shop for 5 months but I can always use another tool!!

    #17465
    Jake Braitman
    Participant
    • Topics: 0
    • Replies: 5

    Does the system work well for sharpening lots of chisels? Pretty repeatable?

    #17496
    wickededge
    Keymaster
    • Topics: 123
    • Replies: 2939

    Are you guys up for a pass around?

    Sent from my SCH-I535 using Tapatalk

    -Clay

    #17530
    Jake Braitman
    Participant
    • Topics: 0
    • Replies: 5

    I just ordered one today. If it is anything like my other wicked edge products I am sure it will work well. I will report my experience with it once I get it and have time to play with it.
    Thanks
    Jake

    #18332
    Richard Jackson
    Participant
    • Topics: 2
    • Replies: 19

    Jake,
    Any review or thoughts? I have some people that may be interested if I was to start sharpening chisels. Thanks!!

    Take care and God Bless!
    Richard

    #18333
    Jake Braitman
    Participant
    • Topics: 0
    • Replies: 5

    Hey Richard. I ended up returning it. It was well machined and worked well for my chisels but I wanted to use it for my handplanes as well. Many of my handplane blades didn’t fit in the jig. I also was not able to get an angle greater than 30 degrees. It might have been user error. I have a bunch of diamond plates already and felt that I would be better suited buying the veritas honing guide, which I can highly recommend. Wicked edges customer service was great and the jig was well made just maybe a little limited for me. I think it would be great if you only have chisels and small hand planes.

    #18376
    Raymond Parker
    Participant
    • Topics: 0
    • Replies: 1

    I just got mine today. I do my chisels at 30 degrees, so that was fine. Next time I have it set up I’ll look into greater than 30. I used a angle-o-meter to set my angle, zeroing the meter on the plane and then setting the arm. I didn’t pay attention to the marks on the slider.

    I, too, wish the jaw was wider. I clamp a bunch of stuff together to make a jig to do the planes, but now can scoot right through the chisels.

Viewing 11 posts - 1 through 11 (of 11 total)
  • You must be logged in to reply to this topic.