Mikeyv
Forum Replies Created
-
AuthorPosts
-
02/08/2017 at 1:47 pm #37216
Welcome to the forum!! A lot of great information here and a lot of great people willing to help out
02/03/2017 at 6:31 pm #37123When useing the vinegar, windex or alcohol are u letting it sit on the stones for a few min or just putting it in and scrubbing?
I love seeing a owner of the company so involved. Thank u for all your hard work and input!!!!
02/03/2017 at 5:14 pm #3712002/03/2017 at 4:47 pm #37119I have noticed that re profiling takes a realllllllyyyyyyy long time!!!! Might start doing it in smaller steps over different snarling periods or just take it to the belt sander
02/03/2017 at 4:40 pm #37118I was inspecting with a loupe often. With that being said it’s a cheap one and after useing it more and more I am learning what to look for. On that particular knife I wasn’t checking the angle with the angle cube during paddle change so it’s very very possible I wasnt hitting the entire apex even tho it looked like it threw my untrained eyes. As for the burr do y’all get a good burr formed that with stop your nail if u run it up it or just enough to feel a slight burr? A knife I did last night I just did matched the prior angle and noticed I could raise a really good burr as where the other knife I could just barely feel the burr. I did notice there is slight variance from paddle to paddle Whitichen a higher grit would mean one might have to work longer to reach the apex.
1 user thanked author for this post.
02/03/2017 at 2:08 pm #37114I haven’t figured out what was wrong yet. I sharpened a different knife last night and went down to the 1500 again. This knife came out pretty sharp. I will get that knife back out to day and inspect it and try it again. I have an esse 4 that I am ready to do. It’s going to be the first knife of decent quality beside my spydico delica which is a beat to crap. After about 15 knifes now nothing has came out super sharp yet even going down to 1 micron film. I have been trying to reprofile a lot of the knife to also help break in the stones. I would think those knifes will get better on follow visits.
1 user thanked author for this post.
01/31/2017 at 3:55 pm #37054Yes I did form a burr on the 800 and 1000 but couldn’t tell on the 1500. I start off with scrubbing one side at a time 1 to help remove the prior scratchs and 2 to help raise the burr then after that do 50-100 swipes of alternating strokes. As for the micro bevel I did use the weight of the paddles only. Only thing I was thinking it that micro bevel did take some of the sharpness away but wasn’t sure if that was possible. Thank u for the responses. I’m still not sure what happened. I used the loupe three the entire prosses and used the sharpie on the apex near the end of every grit
1 user thanked author for this post.
01/26/2017 at 10:04 am #36925Great. I’m very new to the weps and find this forum very very very useful. I’m starting off with just the film. Really just trying to get a consensus from the the veterans on here. Thanks for your input.
01/24/2017 at 7:23 pm #36891Good question as far as the I pad goes. I would be curious to hear if anyone uses a scope on the iPad.
1 user thanked author for this post.
01/24/2017 at 6:14 am #36851I couldn’t find the riser block By it’s self for sell on the web site. I might have missed it tho
-
AuthorPosts