Mark

Well said!!

Thanks Marc.

I do recall reading this at some point. I’m going to keep this in mind moving forward. With the knives that I have done that are slightly off I will try to make adjustments when I touch them up.

Thanks!

Your words are exactly what has been going through my mind over the last day or so. When is it good enough? The perfectionist in me is always striving for that little bit better, more precise, a tighter fitting joint in my woodworking, etc, etc. At the end of the day we are typically our own worst critic and more often than not we are the only…[Read more]

Appreciate the feedback Marc.

I took some more measurements last night, but they’re not necessarily consistent. This could be the cube, changes in the square as it is locked up or the square itself. After my measurements last night I took a closer look at the square and although it is not grossly misshapen it does appear to have seen better days.…[Read more]

Thanks Marc,

Apologies for the explanation. Even writing it was somewhat confusing so I totally understand it not being real easy to follow and picture what I’m describing. In hindsight I should have taken some pictures which would have made describing this and you being able to understand it much easier.

My chamois comment may have been…[Read more]

Hi Marc,

Thanks for the welcome and suggestions.

I use a Tilt Box for measuring angles. The manufacturer claims accuracy of +/- 0.1 but by their own admission 0.2 is more reflective of the accuracy that can be expected from this cube. Although the cube doesn’t have a reset feature I did recalibrate it last night before taking any measurements. I…[Read more]