Got my Gen 3 Pro now and had a go last night. Great fun!
I have a USB microscope. I used the Sharpie as above. I set an angle I thought appropriate to the knife and got the sharpie off right to the edge. Then I wondered if I had to big an angle and was creating a microbevel? So I went the other way until I didn’t quite take the sharpie to the edge. Then worked the other way until I just got it off to the edge. Is that what I should be doing? I then recorded the angle with the cube.
I have only the supplied stones at present. Diamond 1500 arriving in a couple of weeks and I have the 6 micron diamond tape lined up. Question is, with good technique, how sharp can you get a decent kitchen knife with the 1000 grit diamond plate?
Another question, does the advanced alignment guide fit the Gen 3 pro vice? It didn’t seem to on mine unless I’m doing something wrong?
Martin