First Time Using WES

[kpromero]

Thanks for the tips. i will try your suggestions today. thought i was doing good with sharpening until looking after i thought i was done with it. lesson learned.

[CliffCurry]

tcmeyer wrote:

kpromero wrote:

I run bronze bushings on my blocks, which have almost zero clearance. When they feel sticky, I clean them with a .243 rifle brush. The rods also benefit from an occasional wipe-down with alcohol or some such. How did you do this and sounds intereting?

This is a rather difficult procedure and I wouldn’t recommend it unless you have the skills and access to some machine-shop equipment. Cliff Curry, who haunts this forum, has a much simpler solution, I think, with some sleeves which are inserted at the ends of the bores. If he doesn’t chime in here, try to send him a personal message.

Hey guys, Ill make a new post over in MODS regarding the nylon bushing specs and install.  Just got my first micrometer as a gift for Christmas(thx Gib!) so will be a good chance to check it out!

[kpromero]

was able to try it out again and i believe i got somewhat better on this try. i even put a slight polish on it also. Does polishing the edge help the durability or is it just for appearance?

 

Attachments:

You must be logged in to access attached files.

2 users thanked author for this post.

wickededge, Mark76

[Author]

Posts