Removing the gen 3 jaws?
- This topic has 12 replies, 8 voices, and was last updated 03/15/2017 at 11:20 am by
.
-
The jaw pins just push out. I use the allen wrench tool from my gen2. Anything smaller diameter than the pins will do it. The pins don’t need to be removed all the way out, rather push them far enough that the jaws release. The gen2 allen key is the perfect length to push the pins out the right distance. The spring is a non issue. It will usually stay attached to one or the other jaw. I change jaw sets all the time (commercial application). It now takes me 10 seconds max to change a set.
The pins that are the pivot points for the jaws can be removed by simply pushing them out. I have done this to mine and was able to easily able to put it back together. Let me know if you need pictures or further explanation.
I would appreciate if you would do this. I tried to remove the pins once and they seemed very tightly held in place so I gave up. Thanks Marc
I should have some time to do this for you tonight after work.
1 user thanked author for this post.
Step One: Locate the pins that hold the jaws in place.
Step Two: Push the pin out (this does take a moderate amount of force). I used an Allen wrench.
Step Three: When the pin has been removed, lift the jaw out of the clamp. The spring may come with it.
Step Four: Repeat this for the other clamp jaw.
Sorry for the focus on the last photo. I didn’t realize it was blurry until I had already put it back together. I hope that helps!
I figured it was that simple, I just can’t get my pins to move though. Would it hurt to put some oil on the pins? Thanks for taking the time for the pictures as well.
It should be fine. There’s a small chance that it might catch the metal and diamond dust and work it into the pivots if you put a lot of oil on there.
1 user thanked author for this post.
I have always had to hammer (light tapping) my pins out on my gen 3 jaws ( I use the small end of the gen 2 allen key). Been doing it for 1-2 years now since the gen 3 came out been doing fine. Sometimes the holes aren’t lined up perfect in manufacturing so that’s why we have to do this, although ideally they should come from Wicked Edge being able to be pushed out w/ little force (according to clay).
1 user thanked author for this post.
- You must be logged in to reply to this topic.