I’ve been playing with a new angle adjustment prototype from Wicked Edge…
Basically, you mount the knife loosely in the clamp, place the guide over the knife, dial in the angle you want, and tighten. Remove the guide, then set the guide rods to the dialed in angle, and sharpen as normal.
Works pretty well… I’m measuring angles within .0025 of what I’m setting.
If all goes well… should be out later this summer. Felt it was far enough along, that today would be a good day for a ‘sneak peek’.
Enjoy! 
I started to look at the picture and tried to figure out how it works! Thanks! What is it actually? Is it related to sharpening?
