Ok guys. I’m about 10 knives in and getting more and more impressed with the system. But unfortunately My kids ruined my .5 and 1 µm strops. Can’t really say it was their fault it was mine for leaving them where they found them. My question is should I get the same strops again and then make more strops with the handles I have already? Or go with different strops? Also I was debating about getting the 1200 and 1600 grit ceramics. I have ceramics with my Propac two already they just say course in fine. I’m not sure of the grit progression on them. I’m not really sure if I want to get water stones because of the mess and cost. My ultimate goal is to sharpen as a small business within my community of friends and fishing partners. If that helps. As Leo Mitch would say let’s see how far the rabbit hole goes!!!
Actually it was the other Leo, Leo Barr! :lol:
Leo
Opps!!! Lol!!
I would just re-strop them. Clay, do you sell just the leather?
This is possible with Bob Nash @ Oldawan Tools
http://www.oldawan.com/ 505-570-2040
I would highly recommend the roo!
A little diy, i get my leather from a local tandy
http://www.tandyleatherfactory.com/en-usd/home/department/leather-belts-leather-straps/leather-cowhide-strips-straps/4523-190.aspx