Clay,
I have a customer who is waiting for a purchased WEPS and asked me if I had PDF copy of template for drilling base so he could get this done while waiting…
Thanks,
K–
Clay,
I have followed your instructions above and cannot seem to get these Kyocera blades razor sharp!?! They were very (VERY) dull when they came to me; the progression I went thru is as follows… 100/200, 400/600 and then 800/1000.
Never did pull a burr at start (w/ 100), thought maybe since ceramic, burr would not form?
Shall I go (back) to 50/80?
I believe my pressure is OK… not too light.
THANKS–
