Jdcooper79

[Jdcooper79]

I hope you figured out your issue with the Gen 3.. If you talked to Kyle again I’m sure you did because I had the same problem and he told me how to fix it.  But since I didn’t see it answered here I thought I should put it out there.  The Gen 3 has two hex bolts on each rod arm at the base.  Not the micro adjustment that can be done on each arm and tightened with the thumb screw.  These two are side by side and at the base of the arm.  You have to turn the angle out to 27+ to expose them.  They face you on the left side and are facing away on the right side.  If you loosen these two hex bolts the entire arm has about a 2 degree play.  Use an angle cube to get it right.

1 user thanked author for this post.

Alan

[Author]

Posts