Thank you all for the advice. I would like to clarify a few things after reading your replies.
I understand the the sandpaper (P2500 as my sandpaper finisher) is on a different scale then the ceramics are measured. If I was going from P2500 to super fine (1200/1600 grit) then I believe i would bo going backwards. But since i don’t have the super fines (yet), i am jumping to what i do have (micro fine) (1.4/0.6 micron). So I think I am going from a rougher grit (p2500) down to a micro fine 1.4/0.6 micron.
On the “rubbing” the ceramics together, i would like to clarify if i am rubbing the micro’s together (course to course and fine to fine) and/or ceramics to diamond stones. Sorry for all the questions. It makes sense they may need flattening becuase I can see the more mirrored polish (after micro find ceramics) but only on a small portion of the entire edge (from the P2500 clean edge). Pretty much in the center of the entire edge. I am thinking, in the micros current state if i did 1000 passes then they might eventually hit the entire edge.
Thanks again for the responses.
Derek
