Advanced Search

Thin, narrow blades and shallow angle

Recent › Forums › Main Forum › Techniques and Sharpening Strategies › Tips for Specific Knife Grinds and Styles › Thin, narrow blades and shallow angle

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 04/25/2013 at 3:36 am #11146
    Steffen Pedersen
    Participant
    • Topics: 1
    • Replies: 1

    Hello,

    I recently got my WE and I love it. Im thourhg almost 10 knifes and got very decent results from the start, so happy about that.

    I mainly do kitchen knifes as recreational knifes are pretty much prohibited in DK (relative to US), so not so many hobby knifes in circulation.

    I was doing my filet knife which has a narrow thin blade and therefore doesnt pertrude so much over the clamp. I want my filet knifes very sharp and they dont get abused (ie chopping on a board) so I would go for a narrow angle. When setting the knife up with a 15 degree (per side) angle the stone on the right side hits the top clamp screw on the right side of the sharpener.

    So basically my question is – any way to avoid this?

    Im prepared to get an extra shorter screw for this type of situation, but as stated Im in the EU and have a fear that the screw has an imperial thread type. Can anyone confirm this or know what the thread type is?

    Thanks

    04/25/2013 at 4:33 am #11147
    wickededge
    Keymaster
    • Topics: 123
    • Replies: 2940

    An M6-1 will fit just fine.

    -Clay

    04/25/2013 at 4:43 am #11148
    Steffen Pedersen
    Participant
    • Topics: 1
    • Replies: 1

    Thamk you for the prompt reply. I will get one of those.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.