Ken Lau

Ken Lau

Ken Lau replied to the topic Help with clamping thick blade in the forum Welcome Mat 5 years, 5 months ago

Hi TC, I checked my screws and they are indeed 20 tpi. I got a few ordered from ebay. But thanks for your kind offer.
Ken Lau replied to the topic Help with clamping thick blade in the forum Welcome Mat 5 years, 5 months ago

Hi Marc

Thanks for the tips. I don’t have any decent hardware stores near me that will sell this type of screw. My best bet is ebay but I’ll need to check the thread pitch. If its 28 threads per inch, that’s a UNF screw. If it’s 20 tpi, it’s UNC. I’m not sure if I have an imperial pitch gauge. Must check later . I think that it’ll be easier to me…[Read more]
Ken Lau started the topic Help with clamping thick blade in the forum Welcome Mat 5 years, 5 months ago

Hi all,

Just received my new WE Pro Pack 1 and I wanted to test the WE on a fairly thick blade. However I noticed that the lower vise screw is not long enough to push the bottom part of the code to clamp the blade tightly. So my question is this. How long should the vise screw be? I have got 2. One that was installed in the WE and a shorter…[Read more]
Ken Lau became a registered member 5 years, 5 months ago

Forum Statistics