Jon
-
Jon replied to the topic New 130 user with questions in the forum Welcome Mat 4 years, 1 month ago
Thanks again for your reply Marc. I have been starting with the 100/ 200 because I have been re-profiling to a new (lower) dps but I think you are right about a) the stones not being broken in and b) leaving myself with deep scratches because of too much time on the 100/200 grit stone.
I just got done turning my Benchmade Bailout from a Tanto…[Read more]
-
Jon replied to the topic New 130 user with questions in the forum Welcome Mat 4 years, 1 month ago
Wow! Thank you so much for taking the time to write such a thoughtful and helpful reply! Your information re: the LAA explains what I was seeing perfectly and I am going to try your alternating side technique which sounds like it will get me the even bevels I am after.
One other thing I am curious about is grit progression in order to get a…[Read more]
-
Jon replied to the topic New 130 user with questions in the forum Welcome Mat 4 years, 1 month ago
Here are the photos noting the angle cube is reading the same angle but the gross adjustment markings are 2 degrees off from each other.
-
Jon started the topic New 130 user with questions in the forum Welcome Mat 4 years, 1 month ago
Hi Everyone! I recently purchased a WE130 and am about 5 knives into it and having a couple of issues.
- When I use my angle cube to get the same angle on both sides, the left side rod winds up in a significantly different place then the right side rod (when referencing the gross angle markings, not the fine adjustment knob) and I am scratching…
-
Jon became a registered member 4 years, 1 month ago