Eric

[Eric]

Leo, first thank you very much for your reply, appreciate that.

If you don’t mind me asking, do you also check the angle between every stone and adjust if it is different? I just am not understanding that part of it. I’m thinking if I start at 26.85, and I reprofile, even if it is only a little bit of the over all height of the blade the angle has to change slightly, then if I adjust the next stone to 26.85 I’m worried that I now won’t be going to the edge of the blade… or am I just way over thinking it?

[Eric]

Thanks for the help, appreciate it.

So a question, regardless what angle I am starting with (staying with this one just to keep it easy though), if I start at 26.85 dps, starting with 800 say, then go to 1000 and check the edge angle and reset 26.85, won’t the angle be slightly different than what I finished with from the 800? I’m thinking even if I only take off a tiny bit to make sure I am getting a burr on both sides, isn’t the angle going to slightly increase, and then when I go back to 26.85 I won’t be getting to the edge?

[Author]

Posts