Derek
@dkrad1935
active 6 years, 10 months ago-
Derek replied to the topic Chef Knife Challenges for new user in the forum Welcome Mat 6 years, 10 months ago
Hope this helps. Had my wife send a pic
-
Derek replied to the topic Chef Knife Challenges for new user in the forum Welcome Mat 6 years, 10 months ago
will do when I get home…
-
Derek started the topic Chef Knife Challenges for new user in the forum Welcome Mat 6 years, 10 months ago
Sorry for all the posts today! Unpacked new Gen 3 pro last night and worked a few knives. Wanted to try my Chef Knife. So put it in, set digital angle to 14 degrees and started with the 100 grit. The knife is a Wustoff Classic. 14 degrees seemed to allow me to get most of the sharpie off with 1,000 grit in a few swipes. There were some secti…[Read more]
-
Derek replied to the topic New guy grinding his clamps by accident in the forum Welcome Mat 6 years, 10 months ago
I agree Clay – just wish I had known Id need that extra part to work 90% of my knives so I could get it all going faster!!
-
Derek replied to the topic New guy grinding his clamps by accident in the forum Welcome Mat 6 years, 10 months ago
Thanks for the reply – as a lot of my sharpening will be smaller knives this may be something I need to purchase. A little frustrating as I would imagine these smallish kitchen (Steak knives) and small pocket knives have to represent a huge percent of knives to be sharpened. But it is what it is.
-
Derek started the topic New guy grinding his clamps by accident in the forum Welcome Mat 6 years, 10 months ago
I just unpacked my new Gen 3 Pro last night and had to sharpen a few knives. I started with a really old knife (its maybe 80 years old) and had good success with it. Then put in a Wustoff Classic utility knife or maybe a paring knife. Through reading online i found it had a 14 degree bevel but that was too shallow for the clamp. So I ended up…[Read more]
-
Derek became a registered member 6 years, 10 months ago
