Thanks for the Feedback. It’s always nice to hear directly from the man himself. Now I just have to decide at which angle I should reprofile to :S As always, thoroughly impressed with the level of customer service I have received. Take care
I took mine down to 17° per side. It wasn’t holding that edge quite as well as I wanted for the way I was using it (pretty much cutting anything in its path; hard, soft, gritty, whatever…) so I kept adding micro-bevels 1° higher until I finally settled at 20° per side. If I hand’t been using it so hard, it probably would have been fine at the 17° angle.
